1 technical data sheet 75 ohm n female connector clamp/solder attachment for rg11, rg144, rg216, .480 inch d hole confguration connector n female connector interface type rg1 1,rg144,rg216 cable attachment method (shield/contact) clamp/solder body style straight electrical specifcations impedance, ohms 75 mechanical specifcations size length, in [mm] 1.59 [40.39] width/dia., in [mm] 0.75 [19.05] . weight, lbs [g] 0.1 1 [49.9] connector type n female contact material and plating silver body material and plating brass, nickel dielectric type ptfe compliance certifcations (visit www.pasternack.com for current document) rohs compliant y es plotted and other data notes: v alues at 25 c, sea level 75 ohm n female connector clamp/solder attachment for rg11, rg144, rg216, .480 inch d hole from pasternack en - terprises has same day shipment for domestic and international orders. our rf , microwave and fber optic products main - tain a 99% availability and are part of the broadest selection in the industry. click the following link (or enter part number in search on website) to obtain additional part information including price, inventory and certifcations: 75 ohm n female connector clamp/solder attachment for rg11, rg144, rg216, .480 inch d hole PE4515 url: http://www.pasternack.com/n-female-standard-rg11-rg144-rg216-connector-PE4515-p.aspx PE4515 PE4515 rev 75 ohm n female connector clamp/solder attachment for rg11, rg144, rg216, .480 inch d hole
? 2013 pasternack enterprises all rights reserved 2 PE4515 rev dwg title PE4515 notes: 1. unless otherwise specified all dimensions are nominal. 2. all specifications are subject to change without notice at any time. 3. dimensions are in inches [mm]. 4. fits mil-c-17 and equivalent cables. assembly procedures fscm no. 53919 cad file 052002 scale n/a size a 127 1. slide clamp nut (1) & gasket (2) over cable. strip cable as shown. do not nick braid while cutting jacket. taper end of braid to permit assembly of braid clamp (3) slide braid clamp(3) over braid & seat against cable. 2. form braid over clamp nut (3). trim braid back to shoulder. cut dielectric to dimension shown. do not nick center conductor. solder contact to center conductor. remove excess solder. do not over heat dielectric. insert cable assembly into body & tighten. 75 ohm n female connector clamp/solder attachment for rg11, rg144, rg216, .480 inch d hole PE4515 cad drawing
|
